LEMON Manuals: Even more car manuals for everyone

Parking Pawl: Installation

  1. Set the transmission to the "N" range.
  2. Install the parking pawl, parking pawl shaft and return spring.
    Fig 1: Identifying Parking Pawl, Parking Pawl Shaft And Return Spring
    G05022327Courtesy of SUBARU OF AMERICA, INC.
  3. Install the parking support actuator.

    Tightening torque: 10±2 N.m (1.0+0.2 kgf-m, 7.4+1.5 ft-lb) 

    Fig 2: Identifying Parking Support Actuator
    G05022326Courtesy of SUBARU OF AMERICA, INC.
  4. Using the ST, tighten the bolts which tightened in step 4) with specified angle.

    Tightening angle: 17°±2° 

    ST 18854AA000 ANGLE GAUGE

    NOTE: Do not use extension as much as possible.
    Fig 3: Tightening Bolts Using ST (18854AA000) (1 Of 2)
    G05022330Courtesy of SUBARU OF AMERICA, INC.
    Fig 4: Tightening Bolts Using ST (18854AA000) (2 Of 2)
    G05022331Courtesy of SUBARU OF AMERICA, INC.
  5. Make sure that the return spring is sticking out of the parking pole hole.
    Fig 5: Identifying Return Spring
    G05032154Courtesy of SUBARU OF AMERICA, INC.
  6. Install the front vehicle speed sensor. < Refer to INSTALLATION , FRONT VEHICLE SPEED SENSOR. >
  7. Install the center differential carrier. < Refer to INSTALLATION , CENTER DIFFERENTIAL CARRIER. >
  8. Install the extension case. < Refer to INSTALLATION , EXTENSION CASE. >
  9. Install the transmission assembly to the vehicle. < Refer to INSTALLATION , AUTOMATIC TRANSMISSION ASSEMBLY. >