LEMON Manuals: Even more car manuals for everyone

Extension Case Oil Seal: Replacement

  1. Lift-up the vehicle.
  2. Clean the transmission exterior.
  3. Remove the ATF drain plug to drain ATF.
    CAUTION: Immediately after the vehicle has been running or after idling for a long time, the ATF will be hot. Be careful not to burn yourself.
  4. Tighten the ATF drain plug.
    NOTE: Use a new gasket.

    Tightening torque: 20 N.m (2.0 kgf-m, 14.8 ft-lb) 

    Fig 1: Identifying ATF Drain Plug
    G05032056Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the rear exhaust pipe and muffler.
    Fig 2: Identifying Rear Exhaust Pipe And Muffler
    G05032057Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the front exhaust pipe.
  7. Remove the heat shield cover.
    Fig 3: Identifying Heat Shield Cover
    G05032025Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the propeller shaft. < Refer to REMOVAL , Propeller Shaft. >
  9. Using the ST, remove the oil seal.

    ST 398527700 PULLER

  10. Using the ST, install the oil seal.

    ST 498057300 INSTALLER

  11. Install the propeller shaft. < Refer to INSTALLATION , Propeller Shaft. >
  12. Install the heat shield cover.
    Fig 4: Identifying Heat Shield Cover
    G05032025Courtesy of SUBARU OF AMERICA, INC.
  13. Install the front exhaust pipe.
  14. Install the rear exhaust pipe and muffler.
    Fig 5: Identifying Rear Exhaust Pipe And Muffler
    G05032057Courtesy of SUBARU OF AMERICA, INC.
  15. Pour ATF from the oil charge pipe.

    Specified fluid: SUBARU ATF (Part No. K0140Y0700) 

    Recommended fluid: IDEMITSU ATF HP CASTROL TRANSMAX J PENNZOIL QUAKER STATE • PENNZOIL ATF-J 

    NOTE: Use of the recommended fluid is permitted only in regions where the specified fluid is not available.

    Capacity: Fill with the same amount of ATF as drained. 

  16. Check the level and leaks of the ATF. < Refer to AUTOMATIC TRANSMISSION FLUID . >