LEMON Manuals: Even more car manuals for everyone

Diagnostic Procedure

  1. Start engine and warm to operating temperature. Turn ignition switch to off position. Disconnect TCM harness connector. Turn ignition switch to on position. Measure voltage between ground and ECM 26-pin harness connector, terminal No. 15 by backprobing ECM harness connector. See Figure. If voltage is less than 3 volts, go to next step. If voltage is greater than 3 volts, repair short to voltage between ECM and TCM. After repair, replace ECM. See ENGINE PERFORMANCE in appropriate SYSTEM WIRING DIAGRAMS article in ELECTRICAL.
  2. Turn ignition switch to off position. Measure voltage between ground and ECM 26-pin harness connector terminal No. 15 by backprobing ECM harness connector. Shake and wiggle the ECM harness and connector. If voltage is greater than 10 volts while shaking and wiggling harness and connector, locate and repair short to voltage between ECM and TCM harness connectors. If voltage remains less than 10 volts while shaking and wiggling harness and connector, contact authorized Subaru dealership because probable cause is deterioration of multiple parts.