Diagnostic Procedure
- Start and warm engine to normal operating temperature. Turn ignition switch to off position. Turn ignition switch to on position. Measure voltage between ground and ECM 26-pin harness connector, terminal No. 15 by backprobing ECM harness connector. See Figure. If voltage is greater than 3 volts, repair poor connection in ECM connector. If voltage is less than 3 volts, go to next step.
- Turn ignition switch to off position. Disconnect ECM 26-pin harness connector. Measure resistance between ground and ECM 26-pin harness connector, terminal No. 15. If resistance is greater than one megohm, go to next step. If resistance is less than one megohm, repair short to ground between ECM and TCM harness connectors.
- Ensure ignition switch is in the off position. Measure between ECM 26-pin harness connector, terminal No. 15 and TCM 24-pin harness connector, terminal No. 2 (Forester, Impreza and Outback Sport) or terminal No. 2 without sport shift and No. 10 with sport shift (Baja, Legacy and Outback). See Figure and Figure . If resistance is less than one ohm, repair poor contact in ECM or TCM connector. If resistance is greater than one ohm, repair open circuit between ECM and TCM harness connectors.