LEMON Manuals: Even more car manuals for everyone

Diagnostic Procedure

  1. Turn ignition switch to on position. Measure the voltage between ground and ECM 35-pin harness connector, terminal No. 1 by backprobing ECM harness connector. See Figure. If voltage is greater than 10 volts, go to step  3. If voltage is less than 10 volts, go to next step.
  2. Check for poor contact in ECM harness connector. If poor contact is found, repair as necessary. If contact is okay, replace ECM and test system operation.
  3. Turn ignition switch to off position. Disconnect fuel tank sensor control valve 2-pin harness connector. Turn ignition switch to on position. Measure voltage between ground and ECM 35-pin harness connector terminal No. 1. See Figure. If voltage is greater than 10 volts, repair short to voltage between ECM and fuel tank pressure sensor control. See WIRING DIAGRAMS under ENGINE PERFORMANCE in SYSTEM WIRING DIAGRAMS article in ELECTRICAL. If voltage is less than 10 volts, go to next step.
  4. Check for poor contact in ECM harness connector. If poor contact is found, repair as necessary. If contact is okay, replace ECM and test system operation.