LEMON Manuals: Even more car manuals for everyone

Diagnostic Procedure

  1. Perform basic diagnostic procedure. See BASIC DIAGNOSTIC PROCEDURE . If any DTCs other than P0400 exist, diagnose and repair those DTCs. Do not diagnose DTC P0400. If DTC P0400 is only DTC set, go to next step.
  2. Start engine. Using scan tool, observe intake manifold pressure sensor signal. If reading is more than 15.75 in. Hg, check for proper installation of EGR valve, intake manifold pressure sensor and TP sensor. If reading is less than 15.75, go to next step.
  3. Disconnect EGR valve harness connector. Turn ignition switch to on position. Measure voltage between ground and EGR valve harness connector terminals No. 2 and No. 5. See Figure. If voltage is greater than 10 volts, go to next step. If voltage is less than 10 volts, repair open between main relay and EGR valve harness connector.
  4. NOTE: Ensure there is no debris caught between the EGR valve and the valve seat.
  5. Measure resistance between EGR valve terminals No. 1 and No. 2, No. 2 and No. 3, No. 4 and No. 5, and No. 5 and No. 6. If resistance is 20-30 ohms, go to next step. If resistance is not 20-30 ohms, replace EGR valve and test system operation.
  6. Turn ignition to off position. Reconnect EGR harness connector. Turn ignition switch to on position. Measure voltage between ground and ECM harness connector B134 terminals No. 15, No. 16, No. 17 and No. 18. If voltage changes between 0 and 10 volts, repair poor contact in ECM connectors. If voltage does not change between 0 and 10 volts, go to next step.
  7. Turn ignition switch to off position. Disconnect EGR and ECM harness connectors. Measure resistance between ECM harness connector B134 and terminals and EGR valve harness connector terminals. See EGR VALVE CIRCUIT IDENTIFICATION  table. See Figure and Figure . If resistance is less than one ohm, go to next step. If resistance is greater than one ohm, open in appropriate wire between EGR valve and ECM harness connectors.
    EGR VALVE CIRCUIT IDENTIFICATION

    ECM Harness Connector B134 Terminal No. EGR Valve Harness Connector Terminal No.
    15 3
    16 4
    17 1
    18 6
  8. Ensure ignition switch is in the off position. Measure resistance between ground and ECM harness connector B134 terminals No. 13, No. 14, No. 25 and No. 26. See Figure. If resistance is greater than 1 megohm, go to next step. If resistance is less than 1 megohm, repair short to ground in appropriate wire and test system operation.
  9. Check for poor contact at ECM and EGR valve harness connectors. If poor contact is found, repair as necessary. If poor contact is not found, system has returned to normal condition at this time.