LEMON Manuals: Even more car manuals for everyone

Extension Case Oil Seal: Replacement

  1. Set the vehicle on the lift.
  2. Disconnect battery ground cable.
  3. Lift up the vehicle.
  4. Clean transmission exterior.
  5. Drain ATF completely.
    NOTE: Tighten ATF drain plug after draining ATF.

    Tightening torque:  25 N.m (2.5 kgf-m, 18.1 ft-lb)

    Fig 1: Tightening ATF Drain Plug
    G02862487Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the rear exhaust pipe and muffler. Refer to REMOVAL under REAR EXHAUST PIPE and MUFFLER .
  7. Remove the heat shield cover.
  8. Remove the propeller shaft.
  9. Using ST, remove the oil seal.

    ST 398527700:  PULLER ASSEMBLY

  10. Using ST, install the oil seal.

    ST 498057300:  INSTALLER

  11. Install the propeller shaft.
  12. Install the heat shield cover.
  13. Install rear exhaust pipe and muffler. Refer to INSTALLATION under REAR EXHAUST PIPE and MUFFLER .
  14. Pour ATF and check the ATF level. Refer to AUTOMATIC TRANSMISSION FLUID  .