Engaging Gear Is Occasionally Not Possible (LI26.60-P-055839)
WARNING: This page is about the Fortwo Electric Drive, 2D Convertible, which is a different variant/trim than selected.
Publication date: 2013-03-15Reference number: LI26.60-P-055839
ENGAGING GEAR IS OCCASIONALLY NOT POSSIBLE
TECHNICAL SERVICE BULLETIN
Reference Number(s): LI26.60-P-055839 Version 2, Date of Issue:
March 15, 2013
| Smart: | Model series 451.xxx between VIN WME4513011K504485 and WME4514012K633260 |
| Design Group: | 26.60 Gearshift |
| Reason For Change: | Reword Text |
COMPLAINT
Transmission cannot be shifted, and at least one of the following complaints applies:
- - Check Engine lamp lights up
- - ESP warning lamp lights up
- - 3 bars in instrument cluster display
- - The fault memory for the automated manual transmission ( ASG ) has stored the fault codes ( FC ) P2802 and P0707 and additional FCs.
CAUSE
Contact resistance between plug contact to shift actuator
REMEDY
- Disconnect plug connector for both shift actuator motors. Perform visual inspection. (Check connectors including latches, contacts, cable covering for damage) blow out connectors of shift actuator using compressed air with less than 1 bar, then connect again. Please note, that contact spray or contact grease must not be used.
- Fix the electrical feed lines onto the shift actuator as shown in the Figure 1 (Attachment) using cable tie.
- Erase fault memory.
- Teach-in clutch and transmission.
- Perform test drive.
ATTACHMENTS
ATTACHMENTS
| File | Designation |
|---|---|
| Figure 1 |
SYMPTOMS
SYMPTOMS
| Power transmission / Manual transmission / Automated Manual Transmission, Sequentronic ASG / ASG function / Blocks |
| Power transmission / Manual transmission / Automated Manual Transmission, Sequentronic ASG / ASG function / Cannot be shifted |
| Power transmission / Manual transmission / Automated Manual Transmission, Sequentronic ASG / ASG function / Nonfunctional |
CONTROL UNIT/FAULT CODE
CONTROL UNIT/FAULT CODE
| Control unit | Fault code | Fault text |
|---|---|---|
| N15/6 (Sprintshift control module) (TCU_451) | P2802 | The signals from the incremental sensor of component M17 (Gear motor) are implausible. |
| N15/6 (Sprintshift control module) (TCU_451) | P0707 | The signals from the incremental sensor of component M17 (Gear motor) are implausible. |
PARTS
PARTS
| Part number | Designation | Qty | Note | EPC | Other make part |
|---|---|---|---|---|---|
| A 002 997 24 90 | Cable tie | 2 | X |
WORK UNITS
WORK UNITS
| Op. no. | Operation text | Time | Damage code | Note |
|---|---|---|---|---|
| 54-0765 | CHECK WIRING HARNESS FOR SHIFT ACTUATOR | 53223 73 | Disconnect plug connector for both shift actuator motors. Perform visual inspection. (Check connectors including latches, contacts, cable covering for damage) blow out connectors of shift actuator using compressed air with less than 1 bar, then connect again. Please note, that contact spray or contact grease must not be used. Fix the electrical feed lines onto the shift actuator as shown in the figure (Annex 1) using cable tie. |