Removal [06/2015 - ]: Procedure
- PRECAUTION NOTE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Refer to PRECAUTION [06/2015 - ]
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [06/2015 - ]
- REMOVE NO. 2 CYLINDER HEAD COVER
Refer to PROCEDURE - Step 15
- REMOVE V-RIBBED BELT
Refer to REMOVAL [06/2015 - ]
- REMOVE GENERATOR ASSEMBLY
- Remove the terminal cap.
- Remove the nut and disconnect the wire harness from terminal B.
- Disconnect the generator assembly connector.
- Disengage the wire harness clamp from the generator assembly.
- Remove the 2 bolts and generator assembly.
- Remove the bolt and wire harness clamp bracket from the generator assembly.
- Remove the terminal cap.