Disassembly [06/2015 - ]: Procedure
- REMOVE FUEL SENDER GAUGE ASSEMBLY
See step 2
- REMOVE FUEL PUMP
- Disconnect the fuel pump harness connector.
- Disengage the clamp and claw, and disconnect the fuel pump filter hose from the fuel sub-tank.
- Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the fuel filter and fuel pump from the fuel sub-tank.
*a Tube *b Fuel Sub-tank *c Protective Tape NOTE:Do not do anything which may separate the tube from either the fuel suction plate sub-assembly or fuel filter, such as applying excessive force to the tube.
Refer to PRECAUTION [06/2015 - ]
- Using a screwdriver with its tip wrapped with protective tape, disengage the 2 claws and remove the No. 1 fuel suction support from the fuel filter.
*a Protective Tape - Using a screwdriver with its tip wrapped with protective tape, disengage the 5 claws, and remove the fuel pump from the fuel filter.
*a Fuel Filter *b Suction Filter *c Tube *d Protective Tape NOTE:- Do not damage the fuel filter or suction filter.
- Do not remove the suction filter from the fuel pump.
- Do not do anything which may separate the tube from either the fuel suction plate sub-assembly or fuel filter, such as applying excessive force to the tube.
Refer to PRECAUTION [06/2015 - ]
- Disconnect the fuel pump harness connector to remove the fuel pump harness from the fuel pump.
- Remove the O-ring and fuel pump spacer from the fuel pump.
*1 O-ring *2 Fuel Pump Spacer *a 5.0 mm (0.197 in.) NOTE:Be careful not to damage the sealing surface.
HINT:
If the O-ring still remains in the fuel filter, remove it using a wire tip (1 mm diameter) that is formed as shown in the illustration.
- Disconnect the fuel pump harness connector.