Automatic/Continuously Variable Transmission Replacement Precautions (S-SB-0024-14)
Publication date: 2014-10-16Reference number: S-SB-0024-14
AUTOMATIC/CONTINUOUSLY VARIABLE TRANSMISSION REPLACEMENT PRECAUTIONS
TECHNICAL SERVICE BULLETIN
Reference Number(s): S-SB-0024-14, Date of Issue:
October 16, 2014
Superceded Bulletin(s): S-SB-0020-11, Date of Issue:
October 16, 2014
| SCION: | 2004 - 2015 FR-S, iQ, tC, xA, xB, xD |
| SERVICE CATEGORY: | Drivetrain |
| SECTION: | Automatic Transmission/Transaxle |
| COPYRIGHT: | © 2018 Toyota, USA License Agreement TMS1002 |
APPLICABILITY
APPLICABILITY
| YEAR(S) | MODEL(S) | ADDITIONAL INFORMATION |
|---|---|---|
| 2004 - 2015 | FR-S, iQ, tC, xA, xB, xD |
NOTE:
SUPERSESSION NOTICE
The information contained in this bulletin supersedes SB No. S-SB-0020-11
Service Bulletin No. S-SB-0020-11 is Obsolete and any printed versions should be discarded. Be sure to review the entire content of this bulletin before proceeding.
The information contained in this bulletin supersedes SB No. S-SB-0020-11
- Applicability has been updated to include 2015 model year Scion vehicles.
Service Bulletin No. S-SB-0020-11 is Obsolete and any printed versions should be discarded. Be sure to review the entire content of this bulletin before proceeding.
INTRODUCTION
The purpose of this service bulletin is to provide precautions to follow when installing an automatic transmission/transaxle assembly to avoid MIL "ON," shifting issues, and/or transmission damage. Use the information in this bulletin when installing an automatic transmission/transaxle assembly.
WARRANTY INFORMATION
WARRANTY INFORMATION
| OP CODE | DESCRIPTION | TIME | OFP | T1 | T2 |
|---|---|---|---|---|---|
| N/A | Not Applicable to Warranty | - | - | - | - |
PRECAUTIONS
Confirm the following items:
- Both alignment pins are present on the engine block.
- ATF lines and cooler have been flushed with the appropriate ATF type.NOTE: Continuously Variable Transmissions (CVT) require CVT fluid when flushing the cooler.
- Correct torque converter bolts and washers are used.NOTE: Not all applications will use washers on the torque converter bolts.
- All ground straps are in the correct locations and are connected properly.
- Correct shift cable adjustment.
- Correct park/neutral position switch adjustment.
- Transmission fluid level has been set properly.
- Transmission learned values have been reset and/or the compensation code has been input (if applicable) and proper initialization has been performed.