Test Description
The numbers below refer to the step numbers on the diagnostic table.
- 2: Listen for an audible click when the REAR DEFOG relay operates. Command both the on and off states. Repeat the commands as necessary.
- 3: Verifies that the BCM is providing ground input to the REAR DEFOG relay.
- 5: Tests for a short to ground on the rear defog relay control circuit of the REAR DEFOG relay coil.
DTC B0285
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Defogger Schematics Connector End View Reference: Master Electrical Component List in Wiring Systems |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
| 2 |
|
Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems | Go to Step 3 |
| 3 |
|
Go to Step 4 | Go to Step 5 |
| 4 |
|
Go to Step 6 | Go to Step 8 |
| 5 | Test the rear defog relay control circuit of the REAR DEFOG relay for an open, high resistance, or a short to ground. Refer to Circuit Testing
and Wiring Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 11 | Go to Step 7 |
| 6 | Inspect for poor connections at the REAR DEFOG relay. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 11 | Go to Step 9 |
| 7 | Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
in Wiring Systems. Did you find and correct the condition? |
Go to Step 11 | Go to Step 10 |
| 8 | Repair an open or high resistance in the ignition 1 voltage circuit of the REAR DEFOG relay. Refer to Wiring Repairs
in Wiring Systems. Did you complete the repair? |
Go to Step 11 | - |
| 9 | Replace the REAR DEFOG relay. Refer to Relay Replacement (Within an Electrical Center)
or Relay Replacement (Attached to Wire Harness)
in Wiring Systems. Did you complete the replacement? |
Go to Step 11 | - |
| 10 | Replace the BCM. Refer to Control Module References
in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? |
Go to Step 11 | - |
| 11 |
|
Go to Step 2 | System OK |