Exhaust Temperature Sensor: Adjustment/Replacement: Installation
Before installing exhaust temperature sensor, apply anti-seize compound only to the threaded portion of rear oxygen sensor to make the next removal easier.
IMPORTANT:
Never apply anti -seize compound to protector of exhaust temperature sensor.
Anti-seize compound:
SS-30 by JET LUBE
Install the exhaust temperature sensor.
NOTE:
Align the harness (A) of exhaust temperature sensor to the marking (B) of joint pipe, and tighten the screws.
Tightening torque:
21 Nm (2.1 kgf-m, 15.2 ft -lb)
Install the joint pipe.
Connect the battery ground cable to battery.