LEMON Manuals: Even more car manuals for everyone

To fit

NOTE: The spare part pump has a locking pin that holds the pump housing together. Keep the locking pin in place in the pump when fitting.
  1. Clean the contact surface between the pump and the engine.
  2. Spare part:  Remove the protective cover from the pump carefully so that it does not fall apart. Use a finger to hold the spring-loaded plunger in.
    Fig 1: Illustration For Step 2-3
    G03713679Courtesy of SAAB-SCANIA OF AMERICA, INC.
  3. Fit the pump.
    NOTE: The compression spring in the pump must be centered at the lug in the pump housing.

    Tightening torque 25 Nm (18 lbf ft) 

  4. Lower the car to the floor.
  5. Fit the intake hose to the pump. Fit the clamp on the hose and press the hose on the pipe while pressing the clamp to the max. open position.
    Fig 2: Illustration For Step 5-6
    G03713680Courtesy of SAAB-SCANIA OF AMERICA, INC.
  6. Fit the delivery pipe's banjo nipple to the pump. Fit a new seal.

    Tightening torque 32 Nm (24 lbf ft) 

  7. Fit the belt pulley and bolts.
    NOTE: Check that there is no fluid on the belt pulleys.
    Fig 3: Illustration For Step 7-9
    G03713681Courtesy of SAAB-SCANIA OF AMERICA, INC.
  8. Unload the belt tensioner and fit the belt in place.
  9. Tighten the belt pulley bolts.

    Tightening torque 25 Nm (18 lbf ft) 

  10. Lower the car to the floor.
  11. Fit the charge air pipe of the turbocharger as well as the upper charge air hose. Fit the bolt holding the charge air pipe (turbocharger - charge air pipe) to the radiator (upper) without tightening it.
    Fig 4: Illustration For Step 11
    G03713682Courtesy of SAAB-SCANIA OF AMERICA, INC.
  12. Raise the car.
  13. Fit the lower charge air hose to the charge air pipe. Fit the bolt holding the charge air pipe of the turbocharger to the radiator.
  14. Fig 5: Illustration For Step 13
    G03713683Courtesy of SAAB-SCANIA OF AMERICA, INC.
  15. Clean all fluid spill.
  16. Fit the wheel arch liner.
    Fig 6: Illustration For Step 15
    G03713684Courtesy of SAAB-SCANIA OF AMERICA, INC.
  17. Fit the spoiler shield and the lower engine cover.
    Fig 7: Illustration For Step 16
    G03713685Courtesy of SAAB-SCANIA OF AMERICA, INC.
  18. Fit the wheel. See WHEEL .
  19. Lower the car to the floor.
  20. Tighten the bolt of the upper charge air pipe mounting (turbocharger - charge air pipe).
  21. Remove the wedge and the pinch-off pliers.
  22. Fit the upper engine cover.
    Fig 8: Illustration For Step 21
    G03713686Courtesy of SAAB-SCANIA OF AMERICA, INC.
  23. Top up with fluid, bleed the power steering system.