LEMON Manuals: Even more car manuals for everyone

To fit

  1. If necessary, carefully wipe the track rod clean and examine the ball joint.
    IMPORTANT: If sand, gravel or other contaminants enter the ball joint (e.g. if the boot has been defective for a time), the track rod must be changed.
  2. Fit a new gaiter to the track rod and steering gear housing. Fit new clips using 30 16 235 Pliers to secure them.
    Fig 1: Illustration For Step 2-5
    G03713754Courtesy of SAAB-SCANIA OF AMERICA, INC.
  3. Screw on the track rod end the same number of turns as when it was removed.
    NOTE: The left and right track-rod ends are different. The track rod ends should curve slightly backwards when fitted. Markings: L = left-hand side, R = right-hand side.
  4. Bolt the track rod end to the steering swivel member.

    Tightening torque 35 Nm (26 lbf ft) 

  5. Tighten the track rod end's locknut.

    Tightening torque 70 Nm (55 lbf ft) 

  6. Fit the wheel.
  7. Lower the car to the floor.
  8. Check the toe-in and adjust if required.

    For setting values, refer to WHEEL GEOMETRY .