To remove
- Remove the selector lever housing.IMPORTANT: When working on a dismantled selector lever housing, the selector lever should be protected with foam rubber or the like.
- Remove the Gear selector casing.
- Snip the cable tie holding the lead for the lighting button in place.
- Snip the cable tie securing the lead for the electromagnet.
- Remove the pins on the electromagnet cable from the connector, pins 5 and 6. Use 85 80 110 Pin removal tool
- Remove the shift indication display. Remove the screws securing the ignition switch.
- Drill out the rivets.
- Dismantle the selector lever housing.
- Remove the selector lever retaining bolt.
- Remove the selector lever with holder from the base plate.
- Remove the lock washer and tap out the spacer sleeve.
- Detach the selector lever from the holder.