LEMON Manuals: Even more car manuals for everyone

To remove

Fig 1: Illustration For Steps 1
G03515818Courtesy of SAAB-SCANIA OF AMERICA, INC.
  1. Remove the battery cover, battery and battery tray.
  2. Remove the gear selector arm from the transmission. The selector lever must be in position 1.
    Fig 2: Illustration For Steps 2-4
    G03515819Courtesy of SAAB-SCANIA OF AMERICA, INC.
  3. Remove the clamp at the cable bracket.
  4. Remove the cable ferrule from the bracket on the transmission.
  5. Remove the centre console, see INTERIOR EQUIPMENT .
    Fig 3: Illustration For Steps 6, 8-10
    G03515820Courtesy of SAAB-SCANIA OF AMERICA, INC.
  6. Remove the circlip and the anti-rattle clip.
  7. Drive out the pin while removing the end of the cable from the ball.
  8. Remove the screws securing the selector lever housing.
  9. Unplug the selector lever housing's connector.
  10. Lift up the selector lever housing and unplug the electrical connection from the ignition switch. Remove the air duct.
  11. Remove the clamp located beside the locking catches.
    Fig 4: Illustration For Steps 11-14
    G03515821Courtesy of SAAB-SCANIA OF AMERICA, INC.
  12. Carefully press the catches securing the cable ferrule towards each other and remove the cable from the bracket.
  13. Lift out the selector lever housing.
  14. Pull the cable and rubber grommet into the car.
    NOTE: Protect the rear seat upholstery. The cable may contact the rear seat when it is pulled out.