LEMON Manuals: Even more car manuals for everyone

Gear selector position sensor: Fitting

Fig 1: Illustration For Steps 1, 4-5
G03516120Courtesy of SAAB-SCANIA OF AMERICA, INC.
  1. Plug in the connector and mount the sensor on the shaft.
  2. Screw on the gear selector position sensor's nut.

    Tightening torque: 8 Nm (6 lbf ft) 

  3. Refit the lever without tightening it and move the selector lever to position N.

    Lift off the lever and fit tool 87 92 467 ADJUSTMENT TOOL, GEAR SELECTOR POSITION SENSOR .

  4. Clean and lubricate the fluid filler pipe's O-ring with petroleum jelly (Vaseline).
  5. Turn the sensor until that the line marked on it is visible in the center of the tool's notch and tighten the bolts.

    Tightening torque: 25 Nm (18.5 lbf ft) 

    Refit the fluid filler pipe.

    Tightening torque: 22 Nm (16 lbf ft) 

  6. Remove the tool and refit the lever. Before tightening the nut, move the selector lever to position P (to relieve the cable of tension).

    Tightening torque: 25 Nm (18.5 lbf ft) 

  7. Fit the battery tray, the battery and the battery cover. Connect and secure the cables.
    Fig 2: Illustration For Step 7
    G03516121Courtesy of SAAB-SCANIA OF AMERICA, INC.
  8. Check that the engine starts when the selector lever is in positions P and N. The engine should not start if the selector lever is in position R, D, 3, 2 or 1. The reversing light should light up only in position R.
  9. Set the right time on the clock.
    IMPORTANT: On cars with a shift-lock function, incorrect adjustment of the gear selector position sensor could result in disablement of this function (SHIFT-LOCK).