LEMON Manuals: Even more car manuals for everyone

To fit

Fig 1: Illustration For Steps 1-2, 4
G03516837Courtesy of SAAB-SCANIA OF AMERICA, INC.
  1. Fit the lower retaining bolt in the steering column assembly and position the assembly with the wiring harness below and to the right of the steering column shaft. Screw the bolt in a few turns but do not tighten it.
  2. Tighten the upper retaining bolts of the steering column assembly.

    Tightening torque 25 Nm (20 lbf ft)  .

  3. Tighten the lower retaining bolts of the steering column assembly.

    Tightening torque 25 Nm (20 lbf ft)  .

    IMPORTANT: The groove for the bolt in the pinion shaft. 
  4. Align the steering column shaft with the steering gear and tighten the bolt securing them to each other. Make sure that the steering gear bolt enters the milled groove on the pinion shaft.
    WARNING: Under no circumstances is the steering shaft to be separated. 

    Tightening torque 30 Nm (25 lbf ft)  .

  5. Fit the wiring harness in place and fasten it to the steering column assembly.
  6. Lift the dust excluder (gaiter) over the steering wheel adjustment lever, so that the lever protrudes from its hole in the excluder.
    Fig 2: Illustration For Steps 6-7
    G03516838Courtesy of SAAB-SCANIA OF AMERICA, INC.
  7. Fit the holder for the coil spring unit and steering wheel stalk switches with the groove upwards.
  8. Plug in the coil spring unit.
    Fig 3: Illustration For Steps 8-10
    G03516839Courtesy of SAAB-SCANIA OF AMERICA, INC.
  9. Plug in the steering wheel stalk switches and fit them in place.
  10. Refit the upper and lower sections of the Steering column assembly  .
  11. Turn the coil spring unit to the end position and then back two and a half turns.
  12. Fit the steering wheel and tighten the center nut using a torque wrench.
    Fig 4: Illustration For Steps 12-13
    G03516840Courtesy of SAAB-SCANIA OF AMERICA, INC.
    IMPORTANT: Locating groove in steering wheel mounting. 

    Tightening torque 30 Nm (25 lbf ft)  .

  13. Fit the airbag module.
  14. Refit the lower section of the DASHBOARD .