LEMON Manuals: Even more car manuals for everyone

Fault Isolation Procedure

  1. Check additional DTCs in the ECM system:
    • Turn the ignition switch to the ON position.
    • Contact ECM.
    • See whether any of the following DTCs have been recorded: DTCs P1151-P1153, P1261, P1264, P1602-P1608, P1610, P1611, P1613, P1621.
    If any of the above trouble codes are present, follow the relevant fault isolation procedure and then go to step 4. If no codes are present, go to next step.
  2. NOTE: Movement of the throttle arm must not be obstructd by external objects, hoses, cables, etc.
  3. Checking the mechanical operation of the flap:
    • Turn the ignition switch to the OFF position.
    • Wait for 10 seconds.
    • Open and close the flap valve by hand. The flap valve should not bind in any position.
    • The spring should return the flap valve to the stop screw.
    If the flap is functioning correctly, go to step  4. If there is a fault with the flap, first try to see if the fault can be rectified without changing the throttle body. If you are successful, go to step  4. If you are unable to rectify the fault without changing the throttle body, go to step next.
  4. NOTE: Next time the ignition switch is turned to the ON position the limp-home solenoid will be activated. The flap valve will then assume the mechanical limp-home position. It is therefore important to reset the limp-home mechanism AFTER the DTCs have been cleared.
  5. Resetting the limp-home mechanism:
    • Change the throttle body.
    • Turn the ignition switch to the ON position.
    • Clear DTCs (ECM).
    • Turn the ignition switch to the OFF position.
    • Wait for 10 seconds.
    • Reset the limp-home mechanism.
    go to next step.
  6. Checking idling speed:
    • Let the engine run until the radiator fan has started once.
    • Engage the A/C and all the power consumers.
    • Read value: Idle Speed Value Deviation from Requested (ECM).
    If the diagnostic tool shows Max +/- 50 RPM, then the steps taken to rectify the fault were correct and all trouble codes should be cleared from the system. Other values indicate that the fault is still present.
Fig 1: Throttle Body (4-Cyl)
G00207367Courtesy of SAAB-SCANIA OF AMERICA, INC.
Fig 2: Throttle Body (V6)
G00207421Courtesy of SAAB-SCANIA OF AMERICA, INC.