Checking The Fuel Pressure Regulator, V6
WARNING:
Removal of the fuel pressure regulator involves partial dismantling of the car's fuel system. The following points must therefore be observed in connection with this work:
- Work only in a well-ventilated area. If approved equipment for the extraction of fuel vapour is available, be sure to use it.
- Wear suitable gloves. Prolonged contact with fuel can cause skin irritation or dramatist.
- Keep a class BE fire extinguisher near at hand. Be mindful of the danger of sparks caused by short circuits and when connecting and disconnecting leads in electrical circuits.
- No smoking anywhere in the vicinity,
- Wear protective goggles.
- Remove the engine cover.
- Remove the valve cap. Connect the pressure gauge equipment part no. 83 93 852 and the adapter 83 94 744 Fuel pressure gauge adapter to the fuel-injection rail with the "safety" on. Take off the "safety" from the adapter.
- Start the fuel pump with the diagnostic tool.
- Take a reading. It should be 3.0 bar (43 psi).
- Detach the pressure regulator vacuum hose. Connect the vacuum pump 30 14 883 Pressure/vacuum pump to the coupling on the pressure regulator.
- Carefully apply positive pressure. Make sure the fuel pressure increases correspondingly.
- Release the positive pressure and apply negative pressure. Make sure the fuel pressure is reduced correspondingly.
- Release the negative pressure and remove the vacuum pump. Connect the pressure regulator vacuum hose.
- Turn off the fuel pump with the diagnostic tool.
- Put the "safety" on the adapter and remove the pressure gauge equipment from the service nipple. Screw on the valve cap.
- Fit the engine cover.