LEMON Manuals: Even more car manuals for everyone

Checking Residual Pressure, V6

WARNING: Checking residual pressure involves partial dismantling of the car's fuel system. The following points must therefore be observed in connection with this work:
  1. Reduce fuel pressure by removing fuel pump fuse no. 19 while the engine is idling. Turn off the ignition once the engine has stopped and replace the fuse.
    Fig 1: Illustration For Steps 3
    G03506927Courtesy of SAAB-SCANIA OF AMERICA, INC.
  2. Remove the engine cover.
  3. Remove the valve cap. Connect the pressure gauge equipment part no. 83 93 852 and the adapter 83 94 744 Fuel pressure gauge adapter to the fuel-injection rail with the "safety" on. Take off the "safety" from the adapter.
  4. Start the fuel pump with the diagnostic tool.
    Fig 2: Illustration For Steps 4
    G03506928Courtesy of SAAB-SCANIA OF AMERICA, INC.
  5. Take a reading. It should be 3.0 bar (43 psi).
  6. Turn off the fuel pump with the diagnostic tool.
  7. Read the pressure gauge after 20 minutes. The residual pressure should be at least 2.3 bar (33 psi).
  8. Put the "safety" on the adapter and remove the pressure gauge equipment from the service nipple. Screw on the valve cap.
  9. Fit the engine cover.