LEMON Manuals: Even more car manuals for everyone

Checking Fuel Pump Capacity, 4-Cyl.

WARNING: Checking the capacity of the fuel pump involves partial dismantling of the car's fuel system. The following points must therefore be observed in connection with this work:
  1. Remove the engine cover.
    Fig 1: Illustration For Steps 1
    G03506878Courtesy of SAAB-SCANIA OF AMERICA, INC.
  2. Extract the fuel pump fuse no. 19 with the engine running. Switch off the ignition when the engine has stopped.
  3. Detach the return line from the fuel rail. Use 83 95 261 Tools, Fuel line. Use flat pliers to remove the rubber seal from the quick-release coupling.
    Fig 2: Illustration For Steps 3
    G03506879Courtesy of SAAB-SCANIA OF AMERICA, INC.
    IMPORTANT: In all work involving disconnection of the fuel line's quick-release couplings, great care should be taken to avoid damaging the sealing surface of the male coupling half. If the male coupling half is extremely dirty it should be cleaned before disconnection. Also clean the sealing surface after disconnection, if necessary. Use a soft cloth. Lubricate the male coupling half before fitting.
  4. Connect the adapter with the hose 83 94 744 Adapter, fuel pressure testing to the return line from the fuel rail. Place the hose opening in a collecting receptacle.
    Fig 3: Illustration For Steps 4-5
    G03506880Courtesy of SAAB-SCANIA OF AMERICA, INC.
  5. Run the fuel pump for 30 seconds, using the diagnostics tool.

    During 30 seconds of operation the pump should deliver at least 700 ml of fuel to the receptacle.