LEMON Manuals: Even more car manuals for everyone

Replacing The Generator, V6: Refitting

Fig 1: Illustration For Steps 3-4
G03517254Courtesy of SAAB-SCANIA OF AMERICA, INC.
  1. Clean the generator securing points and electrical connections and apply them with Vaseline to prevent oxidation.
  2. Insert the generator through the right wheel housing.
  3. Fit the generator with the two bolts.
  4. Reconnect the cables to the generator.
  5. Remove the wedges between the assembly and subframe.
    Fig 2: Illustration For Steps 6-7
    G03517255Courtesy of SAAB-SCANIA OF AMERICA, INC.
  6. Fit the oil pressure sensor.
  7. Fit the right outboard drive shaft, see DRIVE SHAFT .
  8. Fit the drive belt cover.
    Fig 3: Illustration For Step 8
    G03517256Courtesy of SAAB-SCANIA OF AMERICA, INC.
  9. Fit the front right wheel.
  10. Lower the car.
  11. Refit the belt tensioner.
    Fig 4: Illustration For Steps 11-13
    G03517257Courtesy of SAAB-SCANIA OF AMERICA, INC.

    Tightening torque: 40 Nm (30 lbf ft). 

  12. Fit the generator air intake.
    IMPORTANT: Make a note of the belt's direction of rotation. The belt must be refitted for the same direction of rotation as previously.
  13. Refit the multigroove V-belt.
    NOTE: Make sure that the belt is correctly positioned on all the pulleys.
  14. Reconnect the negative cable to the battery.
  15. Set the clock.