LEMON Manuals: Even more car manuals for everyone

To fit

  1. Remove the transit protection from the pump.
  2. Coat the sealing ring with vaseline and fit it on the pump. Insert the two upper bolts loosely in the pump.
  3. Fit the pump, taking care to prevent it from coming apart.
    Fig 1: Illustration For Steps 3-4
    G03505822Courtesy of SAAB-SCANIA OF AMERICA, INC.
  4. Press the pump against the contact surface and tighten the four bolts.

    Tightening torque: 20 N.m (15 lbf ft).

  5. Connect the delivery pipe to the power steering pump and tighten it using special tool No. 89 96 803. See 1:3 SPECIAL TOOLS . Fit a new seal on the nipple.
    Fig 2: Illustration For Steps 5-9
    G03505823Courtesy of SAAB-SCANIA OF AMERICA, INC.

    Tightening torque: 25 N.m (18 lbf ft) 

  6. Tighten the retaining screw for the dipstick tube together with the delivery pipe bracket on the engine.
  7. Connect the inlet hose to the power steering pump.
  8. Fit the air cleaner.
  9. Fit the cover on the engine.
  10. Raise the car.
  11. Fit and secure the belt pulley. Pry the engine slightly to the left to enable the fitting of the belt pulley.
    Fig 3: Illustration For Steps 11-12
    G03505824Courtesy of SAAB-SCANIA OF AMERICA, INC.

    Tightening torque: 9.5 N.m (7.0 lbf ft) 

  12. Relieve the tension on the belt tensioner and fit the belt. Make sure it is correctly positioned on all the pulleys.
  13. Fit the wheel arch liner, spoiler bottom and sound insulation.
    Fig 4: Illustration For Step 13
    G03505825Courtesy of SAAB-SCANIA OF AMERICA, INC.
  14. Lower the car
  15. Fill up the system with fresh fluid as per specification.
    NOTE:
    • Always use fresh fluid.
    • Do not  turn the steering wheel. Air could then get into the system and be the cause of longer bleeding times.
  16. Run the engine for 5 seconds.
    WARNING: The pump could be damaged if the engine is run for longer than 5 seconds.
  17. Check the fluid level in the reservoir and top up as necessary. At 20°C it should be midway between the MAX and MIN marks.
  18. Start the engine again and run it until the fluid in the reservoir stops bubbling. Use a flashlight to see properly .

    An abnormally loud noise from the pump indicates that there is still some air in the system.

  19. Stop the engine and check the fluid level. Top up as necessary.
  20. Check the pump connections for leaks.