LEMON Manuals: Even more car manuals for everyone

To Fit

  1. Remove the seal from the throttle body and delivery hose.
  2. Carefully connect the charge air pipe to the throttle body and secure with the bolt on the mounting on the cylinder head.

    Man:  Connect the venturi hose to the charge air pipe.

    IMPORTANT: Check the O -ring on the throttle body, replace if necessary. In order to make fitting easier, the O-ring can be lubricated with a thin coat of petroleum jelly or the like part no. 30 06 665
    Fig 1: Illustration For Steps 2-3
    G03503486
    Fig 2: Illustration For Steps 3-4-5-6
    G03503487
    IMPORTANT: To reduce the risk of hoses mounted on the delivery side of the turbocharger coming loose due to low friction at high air pressures, the hoses and connecting pieces must be cleaned thoroughly before fitting. Use a rag dampened with 30 15 815 cleaning agent to wipe clean inside the ends of the hoses. Clean also the connecting pieces. If hose clips are rusty or damaged, they must be replaced with new ones to maintain the correct clamping force.
  3. Connect the charge air hose to the pipe. Tighten the hose clamp and the bolt on the cylinder head.
  4. Plug in the pressure/temperature sensor connector.
  5. Attach the bypass valve and tighten the bypass pipe to the turbocharger intake pipe.

    Tightening torque 6 N.m (4 lbf ft) 

  6. Fit the top engine cover