To fit
- Fit the pump and tighten the bolts.
Tightening torque: 20 N.m (15 lbf ft)
- Fit the delivery pipe with bracket and nipple to the pump.
Tightening torque (nipple): 28 N.m (21 lbf ft)
- Attach the suction hose to the pump and remove the pinch-off pliers.
Tightening torque: 4 N.m (3 lbf ft)
- Fit the pump belt and make sure it is fitted correctly on all the pulleys.
- Fit the air filter unit.
Engine with turbocharger: Fit the hose to the turbo pipe.
Viggen RHD: Fit the brace between the suspension strut towers.
- Fill up the system with fresh fluid as per specification.NOTE:
- Always use fresh fluid.
- Do not turn the steering wheel. Air could then get into the system and be the cause of longer bleeding times.
- Run the engine for 5 seconds.WARNING: The pump could be damaged if the engine is run for longer than 5 seconds.
- Check the fluid level in the reservoir and top up as necessary. At 20°C, it should be midway between the MAX and MIN marks.
- Start the engine again and run it until the fluid in the reservoir stops bubbling. Use a flashlight
to see properly
.
An abnormally loud noise from the pump indicates that there is still some air in the system.
- Stop the engine and check the fluid level. Top up as necessary.
- Check the pump connections for leaks.