Clutch Assembly: Removal
- Position vehicle on ramps. Put transmission in 4th gear. Remove battery. Disconnect ground cable from transmission. On V6 engine, remove 2 shields covering engine. On all engines, disconnect clamps and straps securing positive cable. Disconnect back-up light switch connector.
- Disconnect clutch cable from clutch lever. Release cable rubber damper from retaining clip on transmission. Disconnect oxygen sensor connectors. On 4-cylinder engine, remove resonator along with mass airflow sensor.
- On all engines, install Holder (83 94 835 ) in engine lift brackets. On 4-cylinder engine, push out rubber bushing from left lift bracket. On all engines, place Yoke (83 93 850 ) on wheelhousings. Ensure yoke is in close contact with edges of fenders. Remove load from engine and transmission.
- Remove plastic plug on transmission. Install Locking Pin (87 92 335 ), with ring facing upward, to secure gear position. Disconnect gear rod linkage clamp. Engage 3rd gear so gear rod is released from linkage. Install locking pin with ring in hole.
- Raise and support front of vehicle. Remove front wheels. Remove front exhaust pipe. Remove left and right spoilers under bumper. Remove plastic seal at bottom of right inner fender. Disconnect both ball joints. Place Mobile Jack (83 94 793 ) with Fixture (83 94 801 ) under vehicle. Place Front Holder (83 94 819 ) on fixture and install guide pins. Place Rear Holders (83 94 827 ) on fixture and fit small bosses. Install mobile jack up against carrying frame.
- Remove 2 rear engine support nuts. Remove carrying frame bolts, using care not to lose washers. Lower mobile jack and remove carrying frame. Drain oil from transmission. Using Remover (89 96 654 or 87 92 326 ), pull out left drive shaft. Suspend shaft with wire and install Cover (87 92 244 ) on transmission. Using Remover (89 96 654 ), pull out right drive shaft from intermediate shaft. Suspend shaft with wire.
- Remove 2 intermediate shaft bearing bolts located in bearing bracket. On V6 engine, pull out shaft. On 4-cylinder engine, remove intermediate shaft with bearing bracket. On all engines, install Sealing Cover (87 92 244 ) on transmission. Remove splash plate behind flywheel. Remove 2 engine bracket-to-body bolts. Remove 3 transmission bracket bolts. Remove all engine-to-transmission bolts that can be accessed from under vehicle. On 4-cylinder engine, remove bottom starter motor nut.
- On all engines, lower vehicle. Transmission is now held in place by 3 bolts. Remove 2 outside bolts. Install Lifting Bracket (87 92 368 ) and cable Wire (87 92 251 ) on transmission. Connect cable wire to engine hoist. Lower engine/transmission unit about 1/2". Remove last engine-to-transmission bolt. Remove transmission. Lock flywheel in position. Remove pressure plate bolts. Remove clutch.