LEMON Manuals: Even more car manuals for everyone

Automatic Transmission

NOTE: ATF should only be replaced when engine and transmission are cold.
  1. Raise and support vehicle. See DISABLING/ENABLING ELECTRONIC LEVEL CONTROL  . Remove engine guard. See Figure . Place oil collection pan under transmission. Remove drain plug (B). See Figure . Drain ATF. Install ATF drain plug (B) with NEW sealing ring. Tighten to 21 ft. lbs. (28 N.m).
  2. NOTE: This step is for models equipped with V8 Bi-Turbo engine. On all other models, go to next step.
    Fig 1: Disconnecting Charge Air Cooler (V8 Bi-Turbo - Automatic Transmission)
    G00380499Courtesy of PORSCHE OF NORTH AMERICA, INC.
    Fig 2: Disconnecting Ambient Air Valve Module (V8 Bi-Turbo - Automatic Transmission)
    G00380500Courtesy of PORSCHE OF NORTH AMERICA, INC.
  3. Disconnect connection on charge air cooler, by removing locking clip (1). See Fig 1 . Pull off line. Disconnect lead of ambient air valve module (2), by removing spring band clamp, and pull off line. Disconnect suction line from engine, by removing locking clip (arrow). See Fig 2 . Pull off line.
  4. Undo ATF line screw connection, on cooler side (arrow) at thermostat. See Fig 3 . Counter when releasing ATF lines. Remove screw connection of ATF thermostat holder (arrow). See Fig 4 .
    Fig 3: Removing Cooler Side Connection (Automatic Transmission)
    G00380501Courtesy of PORSCHE OF NORTH AMERICA, INC.
    Fig 4: Removing Thermostat Holder (Automatic Transmission)
    G00380502Courtesy of PORSCHE OF NORTH AMERICA, INC.
  5. NOTE: To prevent distribution of oil in area of front of vehicle, a discharge chute should be hold in position.
    Fig 5: Holding Discharge Chute Under ATF Thermostat (Automatic Transmission)
    G00380503Courtesy of PORSCHE OF NORTH AMERICA, INC.
  6. Hold shop-made tool discharge chute, under ATF thermostat. See Fig 5 . Drain ATF from ATF cooler.
  7. Tighten ATF line screw connection on cooler side (arrow) at thermostat. See Fig 3 . Counter when fastening ATF lines. Install screw connection of ATF thermostat holder (arrow). See Fig 4 . Tighten to 22 ft. lbs. (30 N.m).
  8. NOTE: This step is for models equipped with V8 Bi-Turbo engine. On all other models, go to next step.
  9. Connection suction line to engine, by inserting clocking clip (arrow). See Fig 2 . Push line on until it engages. Connect lead of ambient air valve module (2), by fitting spring band clamp. See Fig 1 . Connect lead. Insert locking clip (1) on charge air cooler suction line, and push line on until it engages.
  10. Remove ATF inspection plug (A). See Figure . Only part of total change quantity can be filled due to test specifications stipulated for ATF. Remaining fluid must be filled as describing in checking ATF. See CHECKING FLUID LEVEL  .
  11. Fill with ATF using special tool oil filler for ATF, until fluid emerges at lifting pipe. Fill approximately 9 qts. (8.5 L). Install oil inspection plug with NEW sealing ring. Tighten to 52 ft. lbs. (70 N.m). Check ATF level. See CHECKING FLUID LEVEL  . Install engine guard.