LEMON Manuals: Even more car manuals for everyone

Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. 2:  Listen for an audible click when the CRANK relay operates. Press the ignition switch back and forth from the ON to Crank positions. Repeat this as necessary.
  2. 3:  Tests for voltage at the coil side of the CRANK relay. The IGN fuse supplies power to the coil side of the CRANK relay.
  3. 4:  Verifies that the ECM is providing ground to the CRANK relay.
  4. 5:  Tests if ground is constantly being applied to the CRANK relay.
DTC P0615

Step Action Yes No
Schematic Reference: Starting and Charging Schematics 
Connector End View Reference: Engine Controls Connector End Views for the 2.0L (LNF) engine or Engine Controls Connector End Views for the 2.4L (LE5) engine
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2 
  1. Install a scan tool.
  2. Turn ON the ignition, with the engine OFF.
  3. Press the ignition back and forth from the ON to Crank positions.
Does the CRANK relay click with each command?
Go to Step 3  Go to Starter Solenoid Does Not Click 
3 
  1. Turn OFF the ignition.
  2. Remove the CRANK relay.
  3. Turn ON the ignition, with the engine OFF.
  4. Connect a test lamp between the battery positive voltage of the CRANK relay coil circuit and a good ground.
Does the test lamp illuminate?
Go to Step 4  Go to Step 8 
4 
  1. Connect a test lamp between the battery positive voltage of the CRANK relay coil circuit and the control circuit of the CRANK relay.
  2. Turn the ignition back and forth from the ON to Crank positions.
Does the test lamp turn ON and OFF with each command?
Go to Step 6  Go to Step 5 
5  Test the control circuit of the CRANK relay for a short to voltage or an open. Refer to Circuit Testing and Wiring Repairs .
Did you find and correct the condition?
Go to Step 11  Go to Step 7 
6 Inspect for poor connections at the CRANK relay. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .
Did you find and correct the condition?
Go to Step 11  Go to Step 9 
7 Inspect for poor connections at the engine control module (ECM). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .
Did you find and correct the condition?
Go to Step 11  Go to Step 10 
8 Repair the battery positive voltage circuit of the CRANK relay. Refer to Connector Repairs .
Did you complete the repair?
Go to Step 11  -
9 Replace the CRANK relay.
Did you complete the replacement.
Go to Step 11  -
10 Replace the ECM. Refer to Control Module References for replacement, setup, and programming.
Did you complete the replacement?
Go to Step 11  -
11
  1. Review and record scan tool Fail Records data.
  2. Clear DTCs.
  3. Operate vehicle within Fail Records conditions as noted.
  4. Using a scan tool, monitor the Specific DTC Information for DTC P0615.
Does the scan tool indicate DTC P0615 failed this ignition?
Go to Step 2  System OK