LEMON Manuals: Even more car manuals for everyone

Assembly Procedure

  1. Install the flow control spring (2) to the hydraulic pump housing assembly (1).
  2. Install the control valve assembly (3).
  3. Lubricate the new O-ring seal (4) with power steering fluid.
  4. Install the O-ring seal (4) on to the O-ring union fitting (5).
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  5. Install the O-ring union fitting (5) into the hydraulic pump housing assembly (1).

    Tighten 

    Tighten the O-ring union fitting to 75 N.m (55 lb ft)

    Fig 1: Power Steering Pump Flow Control Valve
    G01516637Courtesy of GENERAL MOTORS CORP.