LEMON Manuals: Even more car manuals for everyone

Installation Procedure

  1. Position the power steering gear (1) on the vehicle.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the power steering gear mounting bolts (2) to the frame (3).

    Tighten 

    Tighten the bolts to 110 N.m (81 lb ft)

  3. Install the power steering hoses to the power steering gear. Refer to the following procedures:
    Fig 1: Installing Power Steering Gear Mounting Bolts To Frame
    G01516670Courtesy of GENERAL MOTORS CORP.
  4. Install the stabilizer shaft. Refer to STABILIZER SHAFT REPLACEMENT in Front Suspension.
  5. Install the intermediate shaft lower pinch bolt to the power steering gear (2).

    Tighten 

    Tighten the mounting bolts to 20 N.m (15 lb ft)

  6. Install the tie rod ends to the steering knuckle. Refer to TIE ROD END REPLACEMENT - OUTER .
  7. Install the stabilizer shaft links to the control arms. Refer to STABILIZER SHAFT LINK REPLACEMENT in Front Suspension.
  8. Install the tire and wheel assemblies. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION in Tires and Wheels.
  9. Lower the vehicle.
  10. Bleed the air from the power steering system. Refer to BLEEDING THE POWER STEERING SYSTEM .
    Fig 2: Installing Intermediate Shaft Lower Pinch Bolt To Power Steering Gear
    G01516671Courtesy of GENERAL MOTORS CORP.