LEMON Manuals: Even more car manuals for everyone

Fuel Injector Rails: Installation

  1. Ensure injectors are seated into receiver cups on rail with lock rings in place. See FUEL INJECTORS  . Ensure injector holes are clean and all plugs have been removed.
  2. Lubricate injector "O" rings with a drop of clean engine oil to ease installation. Push tip of each injector into its port. Push entire assembly into place until injectors are seated in ports.
  3. Install 3 fuel rail attaching bolts. Lubricate fuel pressure regulator "O" ring with a drop of clean engine oil. Install fuel pressure regulator onto fuel rail. Install fuel pressure regulator attaching bolts, and tighten bolts. Install fuel supply and return tube hold-down bolt. Install vacuum crossover tube hold-down bolt.
  4. Tighten pressure regulator hose clamps. Connect fuel injector wiring harness to engine wiring harness. Connect vacuum harness to fuel rail assembly. Remove covering from lower intake manifold. Clean manifold surface.
  5. Place intake manifold gaskets with beaded sealer facing up on lower manifold. Place air intake plenum in position. Loosely install ignition coil to intake manifold. Install manifold attaching fasteners.
  6. Tighten 8 manifold fasteners. Tighten 2 ignition coil fasteners. Connect fuel line to fuel rail. Tighten hose clamps. Connect vacuum harness to air intake plenum and fuel pressure regulator. Reconnect coolant temperature sensor electrical connector. Connect brake booster supply hose to intake plenum.
  7. Reconnect automatic idle speed motor and throttle position sensor wiring connectors. Connect vacuum/vapor hose harness to throttle body. Install throttle cable and transaxle kickdown linkage (if equipped). Install air inlet hose assembly. Connect negative battery cable. Pressure test system for leaks.