LEMON Manuals: Even more car manuals for everyone

Proportioning Valves: Installation

  1. Lightly lubricate proportioning valve "O" ring with clean brake fluid. Hand start valve into modulator assembly until "O" ring is fully seated against modulator. Using crowfoot, tighten valve to 26 ft. lbs. (35 N.m).
  2. Install brake tube on proportioning valve. Tighten tube nut to 13 ft. lbs. (18 N.m). Connect battery to vehicle using jumper cables. Bleed brake system. See BLEEDING BRAKE SYSTEM  . To complete installation, reverse removal procedure. Road test vehicle to ensure proper ABS operation.
Fig 1: Identifying Proportioning Valve
G94J65598Courtesy of CHRYSLER CORP.