System Precautions
CAUTION:
See the ANTI-LOCK BRAKE SAFETY PRECAUTIONS
article in the GENERAL INFORMATION section.
Before proceeding with diagnosis, read and observe following precautions:
- Ensure battery is fully charged and charging system is functional.
- Avoid overloading Controller Anti-Lock Brake (CAB) circuits.
- When testing voltage or continuity at any module, use terminal side (not wire end) of connector. DO NOT probe through wire insulation.
- DO NOT cause short circuits when performing electrical tests. This will set additional fault messages, making diagnosis of original problem more difficult.
- Certain ABS components cannot be serviced individually. DO NOT attempt to remove or disassemble such components.
- Use only high-impedance DVOM or scan tool to test circuits.
- DO NOT remove or apply power to any control module with ignition on.
- Ensure ignition is off before removing or connecting battery cables, fuses or connectors.