Diagnostic Aids
An intermittent may be caused by a poor connection, rubbed through wire insulation or a wire broken inside the insulation. Check for:
- Poor Connection Or Damaged Harness
Inspect PCM harness connector for backed out terminals, improper mating, broken locks, improperly formed or damaged terminals, poor terminal to wire connection and damaged harness. - Intermittent Test
If connections and harness are okay, monitor a DVOM connected between affected terminal and ground while moving related connectors and wiring harness. If failure is induced, voltage reading will change. - Check for a restriction in EGR tube or passage. Also, ensure excessive carbon has not built up on EGR valve orifices.
NOTE:
Check exhaust system for blockage (possibly a plugged converter) if EGR valve shows signs of excessive heat. Repair cause of restricted exhaust system as necessary. Injector open due to following condition may be cause: Stuck, grounded driver circuit or possible faulty PCM. If conditions are not present, oil should be checked for possible fuel contamination.