LEMON Manuals: Even more car manuals for everyone

Fuel System Pressure Test

NOTE: Trouble shooting and diagnosis of the fuel system should begin with determining fuel injection system pressure. Before performing any test on the fuel system, pressure must be released from the system.
  1. Remove "FUEL PUMP" fuse from fuse block. Crank engine. Engine will start and run until fuel supply remaining in fuel lines is used. Engage the starter again for about 3 seconds to ensure that all fuel is out of lines.
  2. Remove air cleaner and plug thermal vacuum port on throttle body. Remove steel fuel line from between front and rear throttle body units. When removing fuel line, always use 2 wrenches. Install fuel pressure gauge (J-29658 or equivalent) between throttle body units.
  3. Reinstall "FUEL PUMP" fuse in fuse block. Start engine and observe fuel pressure reading. If fuel pressure is not between 9 and 13 psi (.6-.9 kg/cm2 ), proceed to Fuel System Diagnosis chart. If fuel pressure is okay, proceed to step 4).
  4. Depressurize fuel system as described in step 1). Remove fuel pressure gauge and reinstall steel fuel line between throttle bodies. Reinstall "FUEL PUMP" fuse in fuse block. Start engine and watch for fuel system leaks. Remove plug from throttle body thermal vacuum port and reinstall air cleaner.