Compressor Control
DESCRIPTION
- When the A/C compressor activation condition is satisfied while blower motor is activated, A/C auto amp. transmits A/C ON signal and blower fan ON signal to ECM via CAN communication line.
- ECM judges the conditions of each sensor (Refrigerant pressure sensor signal, accelerator position signal, etc.), and transmits the A/C compressor request signal to IPDM E/R via CAN communication line.
- By receiving the A/C compressor request signal from ECM, IPDM E/R turns the smart FET to ON, and activates the A/C compressor.
CONTROL BY A/C AUTO AMP.
Low Temperature Protection Control
When intake sensor detects that evaporator fin temperature is
[-5.0°C (23.0°F) or less, A/C auto amp. requests ECM to turn the A/C compressor OFF, and stops the A/C compressor.
When the air temperature returns to
[1.0°C (33.8°F) ] or more, the A/C compressor is activated.
Refrigerant Discharge Amount Control
- When setting temperature is full cold or air outlet is other than DEF, A/C auto amp. controls the refrigerant discharge amount by adjust the duty ratio of ECV according to required amount of cooling capacity.
- When evaporator temperature is target temperature upper limit value or more, A/C auto amp. increases the discharge amount.
- When evaporator temperature is less than target temperature upper limit value, A/C auto amp. reduces the discharge amount.
Compressor Oil Circulation Control
When the engine starts, A/C auto amp. activates the A/C compressor for a few seconds and circulates the A/C compressor oil once.
CONTROL BY ECM
Compressor Protection Control at Pressure Malfunction
The high-pressure side value that is detected by refrigerant pressure sensor is excessively low or high, ECM requests IPDM E/R to turn smart FET OFF and stop the A/C compressor.
Air Conditioning Cut Control
When the engine condition is high load, ECM transmit smart FET OFF request to IPDM E/R, and stops the A/C compressor.