LEMON Manuals: Even more car manuals for everyone

Additional Service When Replacing TCM: Procedure

CAUTION: Immediately after TCM is replaced or after control valve or transaxle assembly is replaced (after TCM initialization is complete), self-diagnosis result of "P1701", "P1709" may be displayed. In this case, erase self-diagnosis result using CONSULT. After erasing self-diagnosis result, perform DTC P1701 reproduction procedure and check that malfunction is not detected. Refer to "DTC LOGIC " (P1701), "DTC LOGIC " (P1709).
  1. CHECK TCM PART NUMBER 

    Check TCM part number to see whether it is blank TCM or not.

    NOTE:
    • Part number of blank TCM is 310F6-XXXXX.
    • Check the part number when ordering TCM or with the one included in the label on the container box.

    Is the TCM a blank TCM? 

    YES: GO TO 2.

    NO: GO TO  3.

  2. SAVING TCM DATA 

    With CONSULT

    1. Turn ignition switch OFF.
    2. Turn ignition switch ON.
    3. Select "Re/programming, Configuration".
    4. Select "AT/CVT".
      NOTE: If "AT/CVT" is not displayed and TCM data cannot be saved on CONSULT, GO TO 3.
    5. Select "Programming".
    6. Save TCM data on CONSULT according to the CONSULT display.

      : GO TO 3.

  3. REPLACE TCM 

    Replace TCM. Refer to "REMOVAL AND INSTALLATION ".

    : GO TO 4.

  4. LOAD CALIBRATION DATA 
    1. Shift the selector lever to the "P" position.
    2. Turn ignition switch ON.
    3. Check that "P" is displayed on shift position indicator on combination meter.
      NOTE: Displayed approximately 1 - 2 seconds after the selector lever is moved to the "P" position.

      Does the shift position indicator display "P"? 

      YES: GO TO  6.

      NO: GO TO 5.

  5. DETECT MALFUNCTIONING ITEM 

    Check the following items:

    • Harness between the TCM and the ROM assembly inside the transaxle assembly is open or shorted.
    • Disconnected, loose, bent, collapsed, or otherwise abnormal connector housing terminals

      Is the inspection result normal? 

      YES: GO TO  4.

      NO: Repair or replace the malfunctioning parts.

  6. STORE CALIBRATION DATA 
    1. Turn ignition switch OFF and wait for 5 seconds.
    2. Turn ignition switch ON.

      Does the shift position indicator display "P" at the same time when turning ON the ignition switch? 

      YES-1 (TCM is blank): GO TO 7.

      YES-2 (TCM is not blank): WORK END

      NO: Check harness between battery and TCM harness connector terminal. Refer to "DIAGNOSIS PROCEDURE ".

  7. PROGRAMMING 

    With CONSULT

    1. Select "Programming".
    2. Perform programming according to the CONSULT display.

      : WORK END