LEMON Manuals: Even more car manuals for everyone

Disassembly and Assembly: Assembly

  1. Install the front spring lower rubber seat (2) to the front suspension strut.
  2. Compress the front spring (1) using a spring compressor (commercial service tool), and install the front spring to the front suspension strut.
    WARNING: Make sure that the pawls of the two spring compressors are firmly hooked on the front spring. The spring compressors must be tightened alternately so as not to tilt the front spring.
    CAUTION: Face the tube side of the coil spring downward. Align the front spring lower end (A) to the front spring lower rubber seat as shown below.
    Fig 1: Installing Front Spring Lower Rubber Seat To Front Suspension Strut
    G08909311Courtesy of NISSAN NORTH AMERICA, INC.
  3. Install the bound bumper to the strut mount insulator.
    CAUTION:
    • Be sure to install the bound bumper to the strut mount insulator securely.
    • When installing the bound bumper, use soapy water. Do not use machine oil or other lubricants.
  4. Install the strut mount bearing, the bound bumper, and the strut mount insulator to the strut. Temporarily install the piston rod lock nut.
    CAUTION: Do not reuse the piston rod lock nut.
  5. Be sure tab (A) on strut mount insulator is positioned as shown below.
    Fig 2: Identifying Tab On Strut Mount Insulator
    G09556076Courtesy of NISSAN NORTH AMERICA, INC.
  6. Be sure the front spring is properly set in the front spring lower rubber seat. Gradually release the spring compressor (commercial service tool).
    CAUTION: Be sure the strut mount bearing is properly aligned to the strut mount insulator and to the front spring.
  7. Tighten the piston rod lock nut to the specified torque.
  8. Remove Tool (A) from the vise.

    Tool number: ST35652000 (-) 

  9. Remove Tool (A) from the front coil spring and strut.
    Fig 3: Removing Tool From Front Coil Spring And Strut
    G08688986Courtesy of NISSAN NORTH AMERICA, INC.