LEMON Manuals: Even more car manuals for everyone

Steering Gear And Linkage: Assembly

  1. Apply Three Bond 1111B or equivalent to inner socket and turn pinion fully to retract inner socket into gear housing assembly.
  2. Install large end (1) of boot (2) to gear housing assembly.
  3. Install small end (3) of boot (2) to inner socket boot mounting groove.
    Fig 1: Identifying Boot Large And Small End
    G05877437Courtesy of NISSAN NORTH AMERICA, INC.
  4. Install boot clamp to boot small end.
    CAUTION: Do not reuse boot clamps.
  5. Install boot clamp to boot large end using Tool.
    CAUTION: Do not reuse boot clamps.

    Tool number: KV40107300 (-) 

    Fig 2: Identifying Large And Small Boot Clamp
    G08983134Courtesy of NISSAN NORTH AMERICA, INC.
  6. Adjust inner socket to standard length (L), and then tighten lock nut to the specified torque. Check length of inner socket (L) again after tightening lock nut. Make sure that the length is the standard.

    Inner socket length (L): Refer to  "STEERING GEAR "

    CAUTION: Adjust toe-in after this procedure. The length achieved after toe-in adjustment is not necessarily the above value.
    Fig 3: Identifying Inner Socket Length
    G07019602Courtesy of NISSAN NORTH AMERICA, INC.