LEMON Manuals: Even more car manuals for everyone

Diagnosis Procedure

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

  1. INSPECTION START 

    Confirm the detected DTC.

    Which DTC is detected? 

    P0102: GO TO 2.

    P0103: GO TO  3.

  2. CHECK INTAKE SYSTEM 

    Check the following for connection.

    • Air duct
    • Vacuum hoses
    • Intake air passage between air duct to intake manifold

      Is the inspection result normal? 

      YES: GO TO 3.

      NO: Reconnect the parts.

  3. CHECK GROUND CONNECTION 
    1. Turn ignition switch OFF.
    2. Check ground connection E9. Refer to Ground Inspection in "CIRCUIT INSPECTION ".

      Is the inspection result normal? 

      YES: GO TO 4.

      NO: Repair or replace ground connection.

  4. CHECK MAF SENSOR POWER SUPPLY CIRCUIT 
    1. Disconnect mass air flow (MAF) sensor harness connector.
    2. Turn ignition switch ON.
    3. Check the voltage between MAF sensor harness connector and ground.
      MAF sensor Ground Voltage
      Connector Terminal
      F31 2 Ground Battery voltage
      Fig 1: Checking Voltage Between MAF Sensor Terminal 2 And Ground
      G06550985Courtesy of NISSAN NORTH AMERICA, INC.

      Is the inspection result normal? 

      YES: GO TO  6.

      NO: GO TO 5.

  5. DETECT MALFUNCTIONING PART 

    Check the following.

    • Harness connectors E11, F2
    • Junction block connectors E44, E45
    • Harness for open or short between mass air flow sensor and ECM
    • Harness for open or short between mass air flow sensor and IPDM E/R

      : Repair open circuit, short to ground or short to power in harness or connectors.

  6. CHECK MAF SENSOR GROUND CIRCUIT FOR OPEN AND SHORT 
    1. Turn ignition switch OFF.
    2. Disconnect ECM harness connector.
    3. Check the continuity between MAF sensor harness connector and ECM harness connector.
      MAF sensor ECM Continuity
      Connector Terminal Connector Terminal
      F31 3 F13 56 Existed
    4. Also check harness for short to ground and short to power.

      Is the inspection result normal? 

      YES: GO TO 7.

      NO: Repair open circuit, short to ground or short to power in harness or connectors.

  7. CHECK MAF SENSOR INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT 
    1. Check the continuity between MAF sensor harness connector and ECM harness connector.
      MAF sensor ECM Continuity
      Connector Terminal Connector Terminal
      F31 4 F13 58 Existed
    2. Also check harness for short to ground and short to power.

      Is the inspection result normal? 

      YES: GO TO 8.

      NO: Repair open circuit, short to ground or short to power in harness or connectors.

  8. CHECK MASS AIR FLOW SENSOR 

    Refer to "COMPONENT INSPECTION ".

    Is the inspection result normal? 

    YES: GO TO 9.

    NO: Replace mass air flow sensor. Refer to "REMOVAL AND INSTALLATION ".

  9. CHECK INTERMITTENT INCIDENT 

    Refer to "INTERMITTENT INCIDENT ".

    : INSPECTION END