LEMON Manuals: Even more car manuals for everyone

Diagnosis Procedure

Regarding Wiring Diagram information, refer to "WIRING DIAGRAM ".

  1. CHECK STOP LAMP SWITCH CIRCUIT 
    1. Turn ignition switch OFF.
    2. Check the stop lamp when depressing and releasing the brake pedal.
      Brake pedal Stop lamp
      Fully released Not illuminated
      Slightly depressed Illuminated

      Is the inspection result normal? 

      YES: GO TO  4.

      NO: GO TO 2.

  2. CHECK STOP LAMP SWITCH POWER SUPPLY CIRCUIT 
    1. Disconnect stop lamp switch harness connector.
    2. Check the voltage between stop lamp switch harness connector and ground.
      Stop lamp switch Ground Voltage
      Connector Terminal
      E38 3 Ground Battery voltage
      Fig 1: Checking Voltage Between Stop Lamp Switch Terminal 1 And Ground
      G04920627Courtesy of NISSAN NORTH AMERICA, INC.

      Is the inspection result normal? 

      YES: GO TO  4.

      NO: GO TO 3.

  3. DETECT MALFUNCTIONING PART 

    Check the following.

    • Fuse block (J/B) connector E6
    • 10 A fuse (No. 7)
    • Harness for open or short between battery and stop lamp switch

      : Repair open circuit, short to ground or short to power in harness or connectors.

  4. CHECK STOP LAMP SWITCH INPUT SIGNAL CIRCUIT FOR OPEN AND SHORT 
    1. Disconnect stop lamp switch harness connector.
    2. Disconnect ECM harness connector.
    3. Check the continuity between stop lamp switch harness connector and ECM harness connector.
      Stop lamp switch ECM Continuity
      Connector Terminal Connector Terminal
      E38 4 E10 106 Existed
    4. Also check harness for short to ground and short to power.

      Is the inspection result normal? 

      YES: GO TO  6.

      NO: GO TO 5.

  5. DETECT MALFUNCTIONING PART 

    Check the following.

    • Fuse block (J/B) connector E6
    • Junction block connectors E44, E45
    • Harness for open or short between ECM and stop lamp switch

      : Repair open circuit, short to ground or short to power in harness or connectors.

  6. CHECK STOP LAMP SWITCH 

    Refer to "COMPONENT INSPECTION (STOP LAMP SWITCH) ".

    Is the inspection result normal? 

    YES: GO TO 7.

    NO: Replace stop lamp switch. Refer to "REMOVAL AND INSTALLATION ".

  7. CHECK INTERMITTENT INCIDENT 

    Refer to "INTERMITTENT INCIDENT ".

    : INSPECTION END