LEMON Manuals: Even more car manuals for everyone

Diagnosis Procedure

  1. CHECK RUBBER TUBE 
    1. Turn ignition switch OFF.
    2. Disconnect rubber tube connected to EVAP canister vent control valve.
    3. Check the rubber tube for clogging.

      Is the inspection result normal? 

      YES: GO TO 2.

      NO: Clean rubber tube using an air blower.

  2. CHECK DRAIN FILTER 

    Refer to "COMPONENT INSPECTION ".

    Is the inspection result normal? 

    YES: GO TO 3.

    NO: Replace drain filter.

  3. CHECK EVAP CANISTER VENT CONTROL VALVE 

    Refer to "COMPONENT INSPECTION ".

    Is the inspection result normal? 

    YES: GO TO 4.

    NO: Replace EVAP canister vent control valve. Refer to "REMOVAL AND INSTALLATION ".

  4. CHECK IF EVAP CANISTER IS SATURATED WITH WATER 
    1. Remove EVAP canister with EVAP canister vent control valve and EVAP control system pressure sensor attached. Refer to "REMOVAL AND INSTALLATION (EVAP CANISTER) ".
    2. Check if water will drain from the EVAP canister.

      Does water drain from the EVAP canister? 

      YES: GO TO 5.

      NO: GO TO  7.

      Fig 1: Checking EVAP Canister For Water
      G04886541Courtesy of NISSAN NORTH AMERICA, INC.
  5. CHECK EVAP CANISTER 

    Weigh the EVAP canister with the EVAP canister vent control valve and EVAP control system pressure sensor attached.

    The weight should be less than 2.1 kg (4.6 lb). 

    Is the inspection result normal? 

    YES: GO TO  7.

    NO: GO TO 6.

  6. DETECT MALFUNCTIONING PART 

    Check the following.

    • EVAP canister for damage
    • EVAP hose between EVAP canister and drain filter for clogging or poor connection

      : Repair hose or replace EVAP canister. Refer to "REMOVAL AND INSTALLATION (EVAP CANISTER) ".

  7. CHECK EVAP CONTROL SYSTEM PRESSURE SENSOR CONNECTOR 
    1. Disconnect EVAP control system pressure sensor harness connector.
    2. Check that water is not inside connectors.

      Is the inspection result normal? 

      YES: GO TO 8.

      NO: Replace EVAP control system pressure sensor. Refer to "REMOVAL AND INSTALLATION ".

  8. CHECK EVAP CONTROL SYSTEM PRESSURE SENSOR 

    Refer to "COMPONENT INSPECTION ".

    Is the inspection result normal? 

    YES: GO TO 9.

    NO: Replace EVAP control system pressure sensor. Refer to "REMOVAL AND INSTALLATION ".

  9. CHECK INTERMITTENT INCIDENT 

    Refer to "INTERMITTENT INCIDENT ".

    : INSPECTION END