LEMON Manuals: Even more car manuals for everyone

Removal and Installation: Notes

CAUTION:
  • Before removal, disconnect the battery negative terminal.
  • To disconnect the brake tubes, use a flare nut wrench to prevent the flare nuts and brake tubes from being damaged. To connect the brake tubes, use a flare nut torque wrench to tighten to the specified torque.
  • Do not drop the ABS actuator and electric unit (control unit).
  • Do not remove and install the ABS actuator and electric unit (control unit) by holding it by the harness.
  • After installation, bleed the air from the brake lines. Refer to "BLEEDING BRAKE SYSTEM ".
NOTE: When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.