LEMON Manuals: Even more car manuals for everyone

Detailed Flow

  1. GET INFORMATION FOR SYMPTOM 

    Get the detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred).

    : GO TO 2.

  2. CHECK DTC 
    1. Check DTC.
    2. Perform the following procedure if DTC is displayed.
      • Record DTC and freeze frame data (Print them out with CONSULT.)
      • Erase DTC.
      • Study the relationship between the cause detected by DTC and the symptom described by the customer.
    3. Check related service bulletins for information.

      Is any symptom described and any DTC detected? 

      Symptom is described, DTC is detected: GO TO 3.

      Symptom is not described, DTC is detected: GO TO  5.

      Symptom is described, DTC is not detected: GO TO  4.

  3. CONFIRM THE SYMPTOM 

    Confirm the symptom described by the customer.

    Connect CONSULT to the vehicle in "DATA MONITOR" mode and check real time diagnosis results.

    Verify relation between the symptom and the condition when the symptom is detected.

    : GO TO  7.

  4. CONFIRM THE SYMPTOM 

    Confirm the symptom described by the customer.

    Connect CONSULT to the vehicle in "DATA MONITOR" mode and check real time diagnosis results.

    Verify relation between the symptom and the condition when the symptom is detected.

    : GO TO 5.

  5. CHECK NORMAL OPERATING CONDITION 

    Check normal operating condition. Refer to "DESCRIPTION ".

    : GO TO 6.

  6. PERFORM BASIC INSPECTION 

    Isolate the malfunctioning part with the basic inspection. Refer to "PRELIMINARY CHECK ".

    : GO TO  8.

  7. PERFORM DTC CONFIRMATION PROCEDURE 

    Perform DTC Confirmation Procedure for the displayed DTC, and then check that DTC is detected again.

    At this time, always connect CONSULT to the vehicle, and check diagnostic results in real time.

    If two or more DTCs are detected, refer to "DTC INSPECTION PRIORITY CHART " and determine trouble diagnosis order.

    NOTE:
    • Freeze frame data is useful if the DTC is not detected.
    • Perform Component Function Check if DTC Confirmation Procedure is not included in Service Information. This simplified check procedure is an effective alternative though DTC cannot be detected during this check.

      If the result of Component Function Check is NG, it is the same as the detection of DTC by DTC Confirmation Procedure.

    Is DTC detected? 

    YES: GO TO  9.

    NO: GO TO  11.

  8. PERFORM COMPONENT FUNCTION CHECK 

    Perform the component function check for the isolated malfunctioning part.

    : GO TO 9.

  9. DETECT MALFUNCTIONING PART BY DIAGNOSTIC PROCEDURE 

    Inspect according to diagnostic procedure of the system.

    : GO TO 10.

  10. REPAIR OR REPLACE THE MALFUNCTIONING PART 
    1. Repair or replace the malfunctioning part.
    2. Reconnect parts or connectors disconnected during diagnostic procedure.

      : GO TO 11.

  11. FINAL CHECK 

    Check that the symptom is not detected. Perform DTC Confirmation Procedure or Component Function Check again, and then check that the malfunction has been repaired securely.

    Has the malfunction been repaired? 

    YES: Inspection End.

    NO: GO TO  4.