LEMON Manuals: Even more car manuals for everyone

Battery Current Sensor

  1. Reconnect harness connectors disconnected.
  2. Disconnect battery negative cable.
  3. Install jumper cable between battery negative terminal and body ground.
  4. Fig 1: Identifying Jumper Cable
    G08134172Courtesy of NISSAN NORTH AMERICA, INC.
  5. Turn ignition switch ON.
  6. Check voltage between ECM terminal 71 (battery current sensor signal) and ground.
    Fig 2: Checking Voltage At ECM Terminal 71 (Battery Current Sensor Signal)
    G08134173Courtesy of NISSAN NORTH AMERICA, INC.

    Voltage: Approximately 2.5V 

  7. If NG, replace battery negative cable assembly.