LEMON Manuals: Even more car manuals for everyone

Liquid Gasket Application Procedure

  1. Using a scraper (A), remove old liquid gasket adhering to the liquid gasket application surface and the mating surface.
    • Remove liquid gasket completely from the groove of the liquid gasket application surface, mounting bolts, and bolt holes.
  2. Wipe the liquid gasket application surface and the mating surface with white gasoline (lighting and heating use) to remove adhering moisture, grease and foreign materials.
    Fig 1: Removing Liquid Gasket Using Scraper
    G05207143Courtesy of NISSAN NORTH AMERICA, INC.
  3. Attach liquid gasket tube to the tube presser (commercial service tool).

    Use Genuine RTV Silicon Sealant or equivalent. Refer to  "RECOMMENDED CHEMICAL PRODUCTS AND SEALANTS ".

  4. Apply liquid gasket without gaps to the specified location according to the specified dimensions.
    • If there is a groove for liquid gasket application, apply liquid gasket to the groove.
      Fig 2: Applying Liquid Gasket Using Tube Presser
      G04874703Courtesy of NISSAN NORTH AMERICA, INC.
    • As for bolt holes (B), normally apply liquid gasket inside the holes. Occasionally, it should be applied outside the holes. Check to read the text of this manual.
      Fig 3: Identifying Bolt Holes And Groove
      G08128266Courtesy of NISSAN NORTH AMERICA, INC.
    • Within five minutes of liquid gasket application, install the mating component.
    • If liquid gasket protrudes, wipe it off immediately.
    • Do not retighten mounting bolts or nuts after the installation.
    • After 30 minutes or more have passed from the installation, fill engine oil and engine coolant.
    CAUTION: If there are specific instructions in this manual, observe them.