LEMON Manuals: Even more car manuals for everyone

Camshaft Position Sensor (Phase)

  1. Loosen the fixing bolt of the sensor.
  2. Disconnect camshaft position sensor (PHASE) harness connector.
  3. Remove the sensor. Refer to "REMOVAL AND INSTALLATION ".
  4. Visually check the sensor for chipping.
    Fig 1: Checking Sensor For Chipping
    G07144245Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Check resistance as shown in the figure.
    TERMINAL RESISTANCE REFERENCE CHART

    Terminal No. (Polarity) Resistance [at 25°C (77°F)]
    1 (+) - 2 (-) Except 0 or ∞Ω
    2 (+) - 3 (-)
    1 (+) - 3 (-)
    Fig 2: Checking Resistance
    G07144246Courtesy of NISSAN MOTOR CO., U.S.A.
  6. If NG, replace camshaft position sensor (PHASE). Refer to "REMOVAL AND INSTALLATION ".