Intake Air Volume Learn Will Not Complete (NTB11-097)
Publication date: 2011-10-21Reference number: NTB11-097
INTAKE AIR VOLUME LEARN WILL NOT COMPLETE
TECHNICAL SERVICE BULLETIN
Reference Number(s): NTB11-097, Date of Issue:
October 21, 2011
| NISSAN: | All |
| CLASSIFICATION: | EC11-027 |
APPLIED VEHICLES
All
APPLIED DATES
2007 - 2012
SERVICE INFORMATION
If IAVL will not complete using CONSULT:
- While the engine is running, disconnect "Mass Air Flow" (MAF) sensor for 10-15 seconds until MIL (P0102 or P010C) comes on, and then reconnect before
performing "Intake Air Volume Learn" (IAVL).
- If vehicle has two MAF sensors, disconnect only one in prior step and leave the second one connected; then reconnect.
- Engine may stop running when idle reduction occurs. Reconnect MAF sensor and continue to step "b".
NOTE:
If P0102 or P010C were not stored when DTC was confirmed, repeat step "a" until idle is reduced.
- Clear any DTC's that may have set during MAF disconnect.
- Perform IAVL.
- Confirm that idle is now within specification for model and year of vehicle being worked on.
See Electronic Service Manual for procedure to set IAVL and for vehicle idle specifications.